transient voltage suppressors 30kpa series speci?cations are subject to change without notice. please refer to http://www.ruilon.com for current information. electronic s circuit prote ct io n system
page:1 speci?cations are subject to change without notice. please refer to http://www.ruilon.com for current information. transient voltage suppressors - 30 kpa series features mechanical characteristics rating symbol value units peak pulse power dissipation by 10x1000s test waveform (fig.1)(note 1) p ppm 30000 watts steady state power dissipation on ini? nite heat sink at tl=75c (fig. 5) p d 8 watts peak forward surge current, 8.3ms single half sine wave unidirectional only (note 2) i fsm 400 amps maximum instantaneous forward voltage at 25a for unidirectional only (note 3) v f 3.5/5.0 v operating junction and storage temperature range. t j , t stg -55c to 175c c typical thermal resistance junction to lead r ujl 8.0 c/w typical thermal resistance junction to ambient r uja 40 c/w notes: 1. non-repetitive current pulse , per fig. 3 and derated above t a = 25 c per fig. 2. 2. measured on 8.3ms single half sine wave or equivalent square wave, duty cycle=4 perminute maximum. 1. halogen-free 2. rohs compliant 3. typical maximum temperature coef ?cient 4. v br =0.1%xv br @25c x t 5. glass passivated chip junction in p600 package 6. 30000w peak pulse capadility at 10x1000s waveform,repetition rate (duty cycles):0.01% 7. fast response time:typically less than 1.0ps from 0 volts to bv min 8. excellent clamping capability 9. low incremental surge resistance 10. typical ir less than 5a above 12v 11. high temperature soldering guaranteed: 260c/40 seconds / 0.375, \(9.5mm) lead length, 5lbs., (2.3kg)tension 12. plastic package has underwriters laboratory fammability classi?cation 94v-0 tvs devices are ideal for the protection of i/o interfaces,vcc bus and other vulnerable circuits used in telecom, computer , industrial and consumer electronic applications. " y j b m - f b e f e &? 8 , 1 t f s j f t uni bi uni bi anode cathode applications circuit prote ct io n system
transient voltage suppressors - 30 kpa series page:2 speci?cations are subject to change without notice. please refer to http://www.ruilon.com for current information. electriacl characteristics type number reverse stand- off voltage breakdown voltage @i t test current maximum clamping voltage @i pp peak pulse current reverse leakage @v rwm (uni) (bi) v rwm (v) v br min. (v) i t (ma) v c (v) i pp (a) i r (a) 30kpa28a 30kpa28ca 28.0 31.28 50 50.0 606.0 5000 30kpa30a 30kpa30ca 30.0 33.51 50 55.2 548.9 5000 30kpa33a 30kpa33ca 33.0 36.90 50 58.5 517.9 5000 30kpa36a 30kpa36ca 36.0 40.20 50 61.8 490.3 5000 30kpa39a 30kpa39ca 39.0 43.60 20 67.2 450.9 2000 30kpa42a 30kpa42ca 42.0 46.90 10 72.0 420.8 1000 30kpa42a 30kpa42ca 42.0 48.00 10 73.0 415.1 1000 30kpa45a 30kpa45ca 45.0 50.30 5 77.4 391.5 250 30kpa48a 30kpa48ca 48.0 53.60 5 81.6 371.3 150 30kpa51a 30kpa51ca 51.0 57.00 5 86.4 350.7 50 30kpa54a 30kpa54ca 54.0 60.30 5 91.4 331.5 20 30kpa58a 30kpa58ca 58.0 64.80 5 92.4 327.9 20 30kpa60a 30kpa60ca 60.0 67.00 5 102.0 297.1 15 30kpa64a 30kpa64ca 64.0 71.50 5 104.0 291.3 5 30kpa66a 30kpa66ca 66.0 73.70 5 107.0 283.2 5 30kpa70a 30kpa70ca 70.0 78.20 5 109.0 278.0 5 30kpa71a 30kpa71ca 71.0 79.30 5 111.5 271.7 5 30kpa72a 30kpa72ca 72.0 80.40 5 114.0 265.8 5 30kpa75a 30kpa75ca 75.0 83.80 5 119.4 253.8 5 30kpa78a 30kpa78ca 78.0 87.10 5 129.0 234.9 5 30kpa84a 30kpa84ca 84.0 93.80 5 139.2 217.7 5 30kpa90a 30KPA90CA 90.0 100.50 5 146.4 207.0 5 30kpa96a 30kpa96ca 96.0 107.20 5 156.0 194.2 5 30kpa102a 30kpa102ca 102.0 113.90 5 165.6 183.0 5 30kpa108a 30kpa108ca 108.0 120.60 5 175.2 172.9 5 30kpa120a 30kpa120ca 120.0 134.00 5 194.4 155.9 5 30kpa132a 30kpa132ca 132.0 147.40 5 213.0 142.3 5 30kpa144a 30kpa144ca 144.0 160.80 5 223.2 135.8 5 30kpa150a 30kpa150ca 150.0 167.60 5 233.4 129.8 5 30kpa156a 30kpa156ca 156.0 174.30 5 245.0 123.7 5 30kpa160a 30kpa160ca 160.0 178.70 5 252.6 120.0 5 30kpa168a 30kpa168ca 168.0 187.70 5 272.4 111.2 5 30kpa170a 30kpa170ca 170.0 189.90 5 275.0 110.2 5 30kpa180a 30kpa180ca 180.0 201.10 5 290.4 104.3 5 30kpa198a 30kpa198ca 198.0 221.20 5 319.8 94.7 5 30kpa216a 30kpa216ca 216.0 241.30 5 348.6 86.9 5 30kpa240a 30kpa240ca 240.0 268.10 5 387.0 78.3 5 30kpa258a 30kpa258ca 258.0 288.20 5 416.0 72.8 5 30kpa260a 30kpa260ca 260.0 290.40 5 416.4 72.8 5 30kpa270a 30kpa270ca 270.0 301.60 5 436.2 69.5 5 30kpa280a 30kpa280ca 280.0 312.80 5 464.2 65.3 5 30kpa288a 30kpa288ca 288.0 321.70 5 469.0 64.5 5 circuit prote ct io n system
page:3 speci?cations are subject to change without notice. please refer to http://www.ruilon.com for current information. transient voltage suppressors - 30 kpa series ratings and characteristic curves figure 1 - p eak pulse p owe r rating cur ve figure 2 - pulse der ating cur ve figure 3 - pulse w av ef or m figure 4 - t ypical junction capacitanc e figure 5 - st eady stat e po we r der ating cur ve figure 6 - maximum non-repetiti ve p eak f orwa rd surg e curr ent fi fi circuit prote ct io n system
transient voltage suppressors - 30 kpa series page:4 speci?cations are subject to change without notice. please refer to http://www.ruilon.com for current information. soldering parameters fefow condition lead-free assembly pre heat - temperature min (t s(min) ) 150c - temperature max (t s(min) ) 200c - time (min to max) (t s ) 60-180 secs average ramp up rate (liquidus temp (t l ) to peak 3c/second max t s(max) to t l - ramp-up rate 3c/second max refow - temperature (t l ) (liquidus) 217c - time (min to max) (t s ) 60-150 seconds peak temperature (t p ) 260 +0/-5 c time within 5c of actual peak temperature (t p ) 20-40 seconds ramp-down rate 6c/second max time 25c to peak temperature (t p ) 8 minutes max. do not exceed 280c t ( e r u t a r e p m e t) ti me (t) t s(min) t s(max) t l t p t s preheat t l t p e n o z l a c i t i r c p u - p m a r t l to t p ramp-dow n physical specifcations weight 0.045oz., 1.2g case jedec do-201 molded plastic body over passivated junction. polarity color band denotes the cathode except bipolar. termina matte tin axial leads, solderable per jesd22-b102d. flow/wave soldering peak temperature : 265c dipping time : 10 seconds soldering : 1 time environmental specifcations temperature cycle jesd22-a104 pressure cooker jesd 22-a102 high temp. storage jesd22-a103 htrb jesd22-a108 thermal shock jesd22-a106 circuit prote ct io n system
page:5 speci?cations are subject to change without notice. please refer to http://www.ruilon.com for current information. transient voltage suppressors - 30 kpa series dimensions storage conditions: 1. storage temperature: -10c~+40c 2. relative humidity:75%rh 3. keep away from corrosive atmosphere and sunlight. period of storage: 1 year warehouse storage conditions of products packaging part number component package quantity packaging option packaging speci?cation 30kpaxxxxx p600 400 tape & reel ela std rs-296e 30kpaxxxxx-b p600 100 bulk concord packing spec p600 c b a a d dim inches millimeters min max min max 1.000 25.40 0.340 0.360 8.60 9.10 c 0.048 0.052 1.22 1.32 d 0.340 0.360 8.60 9.10 unit:mm part numbering system vo lta ge code (r ef er to the electrical characteristics t able) t ype code: a uni-directional ( 5% vo lt age t olerance) ca b i-directional option code: blank r eel t ape -b bulk pa c kaging series code pa xx xx x x 30k circuit prote ct io n system
page:6 speci?cations are subject to change without notice. please refer to http://www.ruilon.com for current information. ruilongyuan electronics co., ltd. reproducing and modifying information of the document is prohibited without permission from ruilongyuan international inc. ruilongyuan international inc. reserves the rights to make changes of the content herein the document anytime without noti?cation. please refer to our website for the latest document. ruilongyuan international inc. disclaims any and all liability arising out of the application or use of any product including damages incidentally and consequentially occurred. ruilongyuan international inc. does not assume any and all implied warranties, including warranties of ?tness for particular purpose, non-infringement and merchantability. applications shown on the herein document are examples of standard use and operation. customers are responsible in comprehending the suitable use in particular applications.ruilongyuan international inc. makes no representation or warranty that such applications will be suitable for the specifed use without further testing or modifcation. the products shown herein are not designed and authorized for equipments requiring high level of reliability or relating to human life and for any applications concerning life-saving or life-sustaining, such as medical instruments, transportation equipment,aerospace machinery et cetera. customers using or selling these products for use in such applications do so at their own risk and agree to fullyindemnify ruilongyuan international inc. for any damages resulting from such improper use or sale. tel: +86-755-8290 8296 fax: +86-755-8290 8002 e-mail: jack@ruilon.com circuit prote ct io n system
|
